In 2027, make workplace safety & health 100% compliant, cheaper and more efficientRequest a switch check now

Office move and workplace safety & health: before move-in

Merten Precht-RümenapfMerten Precht-RümenapfFounder · 18 November 2026 · 11 min read
Office move and workplace safety & health: before move-in

For an office move in Germany, workplace safety & health has to be in place before move-in, not after: the risk assessment must be updated for the new rooms and, under section 3 (3) ArbStättV, documented before work starts. Floor space, escape routes, fire extinguishers, first aid material, notices and safety training must fit on the first working day at the new site.

The risk assessment is the identification and evaluation of all hazards connected with the work, required by section 5 ArbSchG. Structure and content are covered in the main article on the risk assessment for the office. This article covers the trigger "change of location": what must be settled before the lease, before move-in and in the first weeks afterwards.

Workplace safety checklist for an office move
TopicWhat must be settled before move-inBasis
Risk assessmentupdated and documented for the new roomssection 5 ArbSchG, section 3 ArbStättV
Floor space and ceiling height8 m² for the first, 6 m² for each further workstation in the roomASR A1.2
Escape routes and emergency exitslength normally no more than 35 m, minimum width by number of personsArbStättV Annex 2.3, ASR A2.3
Fire extinguishersbasic provision by floor area, no more than 20 m walking distanceASR A2.2
First aid materialfirst aid kit no more than 100 m or one storey awayASR A4.3
First aiders and fire wardensnumber and distribution across the new floorssection 26 DGUV Regulation 1, ASR A2.2
Escape and rescue plandraw up anew if location, size and use require itsection 4 (4) ArbStättV
Noticesfirst aid notice with new address, floor and first aiderssection 24 (5) DGUV Regulation 1
Safety trainingroutes, emergency exits, assembly point, first aid on day onesection 6 ArbStättV, section 12 ArbSchG
Berufsgenossenschaftreport the new address, changes under section 192 within four weekssection 192 (2) SGB VII

Why does an office move trigger a new risk assessment?

An office move changes the workplace completely, and a risk assessment always describes a specific workplace. Section 3 (1) ArbStättV requires the assessment of hazards when setting up and operating workplaces, and section 3 (2) DGUV Regulation 1 requires a review as soon as operating conditions have changed. The old assessment therefore does not carry over to the new site.

It does not have to be written from scratch, though. Tasks, work equipment and working time models move along and stay in the assessment. Everything tied to the building has to be assessed anew: room sizes, traffic routes, stairs, lighting, indoor climate, noise, sanitary and break rooms, escape routes and the emergency organisation.

Timing is what matters. Section 3 (3) ArbStättV requires documentation before work starts. Updating vs. redoing is not a difference in duty but in effort: the existing assessment gets a new chapter on the workplace, with a date and a note on what applied until the move. The minimum values per room are in the article on the Workplace Ordinance for offices.

Which floor space and room dimensions must the new office meet?

Under ASR A1.2 a workroom needs at least 8 square metres for the first and 6 square metres for each further workstation. As a planning value, ASR A1.2 names 8 to 10 square metres per workstation in cellular offices and 12 to 15 square metres in open-plan offices, including furniture and a share of circulation space. Clear ceiling height is at least 2.50 metres for rooms of up to 50 square metres.

Workstations are counted, not heads. A company with 60 employees and 40 shared desks plans with 40 workstations, but must size first aiders and fire wardens by the people actually present.

What three office sizes need at the new site (assumption: all employees present at the same time, one open-plan room per company)
Requirement12 workstations40 workstations90 workstations
Minimum room area (8 m² plus 6 m² per further workstation, ASR A1.2)74 m²242 m²542 m²
Planning value open-plan office (12 to 15 m² per workstation, ASR A1.2)144 to 180 m²480 to 600 m²1,080 to 1,350 m²
Minimum width of main escape route (ASR A2.3)1.00 m (up to 20 persons)1.20 m (up to 200 persons)1.20 m (up to 200 persons)
First aiders (section 26 DGUV Regulation 1)125 (4.5 rounded up)
Fire wardens (5 percent, ASR A2.2)125 (4.5 rounded up)
First aid kit (ASR A4.3)1 small (DIN 13157)1 small (DIN 13157)1 large (DIN 13169)

The minimum is a hard limit, the planning value an empirical one. An offer promising 40 workstations on 300 square metres is above the minimum but far below the planning value for open-plan offices.

What applies to escape routes, fire extinguishers and first aid at the new site?

Escape routes, fire extinguishers and first aid material are planned completely anew at the new site, because they depend on floor plan and headcount. Under ASR A2.3 an escape route may normally be no longer than 35 metres, and the main escape route must be at least 0.90 metres wide for up to 5 persons, 1.00 metre for up to 20 persons and 1.20 metres for up to 200 persons.

For fire extinguishers, ASR A2.2 calculates in extinguishing agent units: 6 units for the first 50 square metres, more with growing area, separately per storey. From any point, the nearest extinguisher should be reachable within 20 metres walking distance.

Under ASR A4.3 first aid material must be no more than 100 metres walking distance or one storey away from permanent workstations. If the office spreads over several floors or long corridors, one first aid kit is therefore often not enough, even if headcount only calls for one. The first aid kit calculator gives the exact provision, the first aider calculator the number of helpers.

Whether a new escape and rescue plan is needed is decided by section 4 (4) ArbStättV according to location, size and type of use. When the duty applies and what the plan must show is covered in the article on the escape and rescue plan in the office. In a building with several tenants, stairwells, assembly point and evacuation drill must be coordinated with the other employers under section 8 ArbSchG.

What changes for safety training, notices and inspections?

Training is due on the first working day in the new rooms, because all site-related content is new. Section 6 (2) and (3) ArbStättV require instruction on first aid, fire prevention, conduct in case of fire and the use of escape routes and emergency exits. Under section 6 (4) ArbStättV the instruction must be repeated without delay after substantial changes that involve additional hazards. The remaining content of the annual training stays as it is.

Among notices, the first aid notice is forgotten most often. Section 24 (5) DGUV Regulation 1 requires current information on emergency calls, first aiders and first aid facilities. After a move, neither address nor floor nor the nearest accident insurance doctor is correct. The first aid notice generator produces a new template, and the remaining duties are listed in the article on mandatory notices in the office.

Electrical equipment does not need an early test because of transport: section 5 DGUV Regulation 3 names first use, a modification or repair and the recurring interval as occasions. A visual check for crushed cables and damaged housings after unpacking is still called for.

Who must be involved and informed in an office move?

The workplace safety specialist, the company doctor and, where one exists, the works council must be involved. Under section 6 ASiG the workplace safety specialist advises on the planning of facilities and the design of workstations. Section 90 BetrVG obliges the employer to inform the works council in good time about the planning of office space and workstations.

In standard support under DGUV Regulation 2, a move is a typical occasion for company-specific support, in addition to basic support. Companies with more than 20 employees put the move on the agenda of the workplace safety committee.

The Berufsgenossenschaft receives the new address. Section 192 (2) SGB VII requires notice within four weeks of changes to the type and object of the business, to the conditions for hazard classes and to the basis for calculating contributions. A mere change of address is not expressly named in section 192 SGB VII. If the activity changes with the location, for example through a new warehouse or workshop, the four-week deadline applies.

What does the workplace safety timeline for an office move look like?

Workplace safety & health starts before the lease and ends with a walk-through a few weeks after move-in. Six steps are enough for an office. Only one point in time is fixed by law: under section 3 (3) ArbStättV the risk assessment must be documented before work starts. All other time figures are empirical values.

  1. Check before signing the lease. Compare floor plan, escape routes, ceiling heights and number of workstations with ASR A1.2 and ASR A2.3.
  2. Involve the safety specialist and works council. Discuss the layout with the workplace safety specialist, the company doctor and the works council.
  3. Update the risk assessment. Assess the new rooms, define measures and document them before work starts.
  4. Set up the emergency organisation. Define extinguishers, first aid kits, first aiders, fire wardens, assembly point and the escape and rescue plan.
  5. Train employees. Show routes, emergency exits, assembly point and first aid on day one and keep a record.
  6. Inspect after move-in. Walk through the occupied space after two to four weeks and update the risk assessment.

The walk-through after move-in finds what no plan shows: moving boxes in the corridor, blocked emergency exits, cables across traffic routes, glare at window desks. The office safety checklist serves as a test list.

Safety Club supports the change of location with an on-site workplace safety specialist and keeps the risk assessment, training records and measures digitally in the customer portal. The process shows how support starts, and an initial call settles open questions about the move.

This article is general guidance and does not replace legal advice. The applicable regulations and the requirements of your statutory accident insurer prevail.

Frequently asked questions

Your question is not listed? We answer it in the initial consultation.

Get a consultation
What do you need to consider for an office move?

For an office move, the risk assessment under section 5 ArbSchG and section 3 ArbStättV must be updated for the new rooms and documented before work starts. Add to that floor space under ASR A1.2, escape routes, fire extinguishers, first aid material, current notices and safety training on the new routes and facilities.

Does the risk assessment have to be redone after a move?

It has to be updated, not started from scratch. Tasks and equipment usually stay the same, while rooms, routes, lighting, indoor climate and the emergency organisation change. Under section 3 (3) ArbStättV the risk assessment must be documented before work starts, so before the first working day at the new site.

Is new safety training required after the move?

Yes. Section 6 (2) and (3) ArbStättV require that employees know the escape routes, emergency exits, first aid and what to do in case of fire. All of that is new at the new site. The training belongs on the first working day in the new rooms and is recorded with date and participants.

Do I have to report the office move to the Berufsgenossenschaft?

Section 192 (2) SGB VII requires notice within four weeks of changes to the type and object of the business, to the conditions for hazard classes and to the basis for calculating contributions. A mere change of address is not expressly named. The accident insurer should still receive the new address at once so that notices and deadlines arrive.

Does electrical equipment need to be retested after the move?

Section 5 DGUV Regulation 3 names first use, a modification or repair and the recurring interval as test occasions, not transport. A visual check of all devices and cables for transport damage makes sense. For the fixed electrical installation of the building, ask the landlord for the test record.

Who is responsible for escape routes and fire extinguishers, landlord or tenant?

Toward its own employees the employer is responsible, regardless of the lease. The lease only governs who provides and maintains equipment. If several employers use the same building, section 8 ArbSchG requires cooperation, for example on stairwells, the assembly point and evacuation drills.

Never miss an article

New articles on workplace safety & health in the office, straight to your inbox.

Worry-free workplace safety & health in 4 steps

A simple path from the first conversation to audit-proof documentation.

Get a consultation

Free initial consultation

We set out what the law requires, what you don't need and what we deliver. Clarity from day one.

Contract signed

One contract, predictable annual costs, booked directly with us. First contact to signature: five working days at most.

Start of on-site support

Your specialist visits for the inspection, produces the risk assessment and checks: what is there, what is missing?

Audit-proof documentation in the portal

Every record sits in the client portal: digital, complete, current, easy to share.

Talk to us

Merten Precht-Rümenapf
Merten Precht-RümenapfYour point of contact and founder at Safety Club
Book a slot directly
The booking calendar is loading.
Or write to us

The trial inspection is non-binding and does not replace an inspection by a specialist.